Rebuilding the clutches in a '98 Mountain SRX 700. Running at 1800', trail riding. Sheave bushing walked out, decided to rebuild clutches due to no history on them.
Current Setup:
8DN-00 weights, dissimilar rivets in each hole, total mass is 51g
14.5mm rollers
Hi Tech Encapsulated Roller secondary
48 Helix (suspected to be a Hauck)
Would run factory settings but it appears to have different mass in the weights and the ER & helix change from the stock Yamaha Red spring.
Looking for clutch springs suggestions for both primary and secondary. Old ones have paint marks worn off. Sled was only pulling 8100 rpm and had poor backshift, springs are atleast 10+ years old.
Thanks in advance.
Current Setup:
8DN-00 weights, dissimilar rivets in each hole, total mass is 51g
14.5mm rollers
Hi Tech Encapsulated Roller secondary
48 Helix (suspected to be a Hauck)
Would run factory settings but it appears to have different mass in the weights and the ER & helix change from the stock Yamaha Red spring.
Looking for clutch springs suggestions for both primary and secondary. Old ones have paint marks worn off. Sled was only pulling 8100 rpm and had poor backshift, springs are atleast 10+ years old.
Thanks in advance.